French industrial expertise · Since 1994
DAS
Industrial dust collector
A dust collector for intermittent production cycles, with motorised filter cleaning when stopped at the end of each cycle.
Technical data sheet available in French.
01 / The right application
Daily intermittent use
The DAS range suits daily intermittent use. Filter cleaning relies on vibration generated by an eccentric driven by a secondary motor. Cleaning takes place while stopped, at the end of the cycle. Five models cover low and medium pressure configurations.
Contact us02 / How it works
DAS
- The motor and fan assembly creates negative pressure. Dust laden air enters the settling chamber.
- Coarse dust falls by gravity into the bucket or drawer; fine particles are retained on the filter element.
- At the end of the cycle, with the fan stopped, the secondary motor drives the eccentric to vibrate and clean the filters.

03 / Technical specifications
Technical specifications
| Model | Airflow m³/h · BP / MP |
Pressure mm WC · BP / MP | Power kW · BP / MP |
|---|---|---|---|
| 120 | 800 / 400 | 70 / 160 | 0.37 / 0.75 |
| 150 | 1 200 / 600 | 100 / 175 | 0.75 / 0.75 |
| 200 | 2 400 / 1 500 | 125 / 260 | 1.5 / 2.2 |
| 250 | 4 000 / 2 500 | 140 / 300 | 3 / 4 |
| 400 | 5 000 / 3 000 | 130 / 300 | 5.5 / 4 |
BP: low pressure · MP: medium pressure. Values from the technical data sheets. General range summaries may differ from individual model values; the table details the listed configurations. Final selection depends on the operating point.
2 mm electrogalvanised steel with epoxy powder coating. 400 V supply. Spare parts available for 10 years.
04 / Options and variants
Options and variants
Options are selected according to the pollutant, ductwork and operating conditions.
304 / 316 L stainless steel variants and different orientations to suit the layout.
PTFE or antistatic filter media depending on configuration.
ATEX variant available subject to configuration and risk assessment.
Your industrial project
Select the right equipment.
Tell us about the pollutant, the required airflow and your production schedule. Our team will help you select the model and its options.
Contact us
Let’s talk about your installation.
A technician from our engineering office studies your needs and proposes the right solution for your workshop: machine, capture, ductwork and filtration.
Reply within 48 working hours.
Your request, step by step
-
1
You describe your needs
Pollutant, workstations, constraints: a few lines are enough. A photo of the installation helps us a lot.
-
2
Our engineering office studies it
Capture, airflow, ductwork and filtration are sized for your site, together with you if anything needs clarifying.
-
3
You receive a written proposal
Machine, options and price, in detail: you decide with full knowledge of the facts.
- Since 1994in industrial air treatment
- In-house engineering officefrom design to supply
- All brandsfilters and spare parts
- French Fabnetwork member

Bag-type DA
DA
DAS CC
HYDRO