French industrial expertise · Since 1994

Galvanised spiral duct and ductwork accessories

Galvanised spiral duct and clamp-together smooth duct, all diameters, with bends, tees, reducers, dampers and slide gates: quoted from a drawing or a list.

Galvanised spiral ducts

01 / Spiral duct

Spiral duct

Spiral duct is made from a strip of galvanised steel wound in a helix and seamed. The seam makes it rigid: it is used for general ventilation, extraction, supply air and make-up air systems.

Sections and fittings slot together and are fixed with rivets or screws, with a gasket or sealant depending on the airtightness required.

02 / Spiral duct

Clamp-together smooth duct for extraction

For dust extraction systems, smooth duct joined with clamps offers an inner wall without a seam: lower pressure drop and fewer deposits.

It can be dismantled and modified as the workshop changes.

03 / Spiral duct

Accessories

Pressed or segmented bends, tees, Y-branches and take-offs for junctions, reducers, butterfly dampers to balance the branches, slide gates to isolate a workstation, silencers and roof outlets.

04 / Spiral duct

Choosing the diameter

The diameter follows from the airflow and the target air velocity: about 7 to 10 m/s for fumes, more than 20 m/s for heavy dust.

Our online sizing tool gives the recommended diameter and the pressure drop.

05 / Spiral duct

Ordering

Send us your drawing or your list: diameters, lengths, number and angle of bends, junctions and accessories. We quote the whole ductwork system.

Useful answers

Frequently asked questions

What is the difference between spiral duct and smooth duct?

Spiral duct, seamed in a helix, is rigid and economical for ventilation. Clamp-together smooth duct, with no internal seam, limits pressure drop and deposits: it is preferred for dust extraction.

Which diameters do you offer?

All the usual ventilation and extraction diameters. Give us the diameter and length of each section.

How is a duct diameter calculated?

Divide the airflow by the target air velocity to obtain the cross-section, then take the nearest standard diameter. Our online tool does the calculation.

Your industrial project

Tell us what you need.

Send us your drawing or your list of ducts and accessories: we quote the whole ductwork system.

Contact us

Let’s talk about your installation.

A technician from our engineering office studies your needs and proposes the right solution for your workshop: machine, capture, ductwork and filtration.

Reply within 48 working hours.

Your request, step by step

  1. 1

    You describe your needs

    Pollutant, workstations, constraints: a few lines are enough. A photo of the installation helps us a lot.

  2. 2

    Our engineering office studies it

    Capture, airflow, ductwork and filtration are sized for your site, together with you if anything needs clarifying.

  3. 3

    You receive a written proposal

    Machine, options and price, in detail: you decide with full knowledge of the facts.

  • Since 1994in industrial air treatment
  • In-house engineering officefrom design to supply
  • All brandsfilters and spare parts
  • French Fabnetwork member
Call Contact us