French industrial expertise · Since 1994

Dampers, slide gates and accessories for extraction ductwork

Balancing dampers, slide gates, flap valves, bends, junctions, silencers and roof outlets: the accessories that make an extraction system work.

Control damper for a ventilation duct

01 / Dampers and accessories

Balancing: the damper

In a system with several branches, air takes the easiest path: the hoods close to the fan extract too much, the furthest ones not enough. A butterfly damper on each branch adds the pressure drop that rebalances the airflows.

The adjustment is made at commissioning, with measured airflows, then the damper is locked.

02 / Dampers and accessories

Isolating a workstation: the slide gate

A slide gate closes the branch of an idle workstation. The ductwork then carries only the airflow of the workstations in use: the fan and the filter are sized on actual simultaneous use, not on the sum of all workstations.

With a pneumatic actuator linked to the machine, the gate opens and closes automatically.

03 / Dampers and accessories

Limiting pressure drop

Long-radius bends, junctions at 30 or 45° rather than 90°, gradual reducers: each well-chosen accessory reduces the pressure required from the fan, and therefore its power and consumption.

A silencer at the fan outlet and a suitable roof outlet complete the system.

04 / Dampers and accessories

Ordering

Send us your drawing or your parts list with the diameters: we quote the whole system. Our online tool helps you build the list and check the diameter of each section.

Useful answers

Frequently asked questions

What is a balancing damper for?

To distribute the airflow between the branches of a system: without it, the hoods close to the fan extract too much and the furthest ones not enough.

Why a slide gate on each workstation?

To close idle workstations. The fan and the filter are then sized on the workstations actually used at the same time.

Your industrial project

Tell us what you need.

Send us your drawing or your parts list with the diameters: we quote the whole ductwork system.

Contact us

Let’s talk about your installation.

A technician from our engineering office studies your needs and proposes the right solution for your workshop: machine, capture, ductwork and filtration.

Reply within 48 working hours.

Your request, step by step

  1. 1

    You describe your needs

    Pollutant, workstations, constraints: a few lines are enough. A photo of the installation helps us a lot.

  2. 2

    Our engineering office studies it

    Capture, airflow, ductwork and filtration are sized for your site, together with you if anything needs clarifying.

  3. 3

    You receive a written proposal

    Machine, options and price, in detail: you decide with full knowledge of the facts.

  • Since 1994in industrial air treatment
  • In-house engineering officefrom design to supply
  • All brandsfilters and spare parts
  • French Fabnetwork member
Call Contact us