French industrial expertise · Since 1994
ATEX fans for explosive atmospheres
Centrifugal fans in ATEX execution for extracting combustible dust or flammable vapours, defined according to your site’s zoning.

01 / ATEX fans
When an ATEX fan is needed
As soon as the fan handles an explosive atmosphere or is located in a classified zone: solvent vapours, combustible dust such as light metals, flour or organic powders.
The zoning appears in your explosion protection document: zones 0, 1 or 2 for gases and vapours, 20, 21 or 22 for dust. The fan must comply with Directive 2014/34/EU, in the category corresponding to the zone, inside as well as outside.
02 / ATEX fans
What changes in the construction
An ATEX execution removes ignition sources: non-sparking materials between the impeller and the inlet, sufficient clearance between the impeller and the casing to avoid any contact, earthing continuity and a motor certified for the zone.
On our ranges, the construction is defined with your risk analysis, for the air conveyed as well as for the fan’s location.
03 / ATEX fans
The data to provide
The internal and external zoning, the nature of the product (safety data sheet) or of the dust, the temperature, the airflow and the pressure.
For dust, the explosion characteristics, such as Kst or minimum ignition energy, complete the file.
Useful answers
Frequently asked questions
What is a non-sparking fan?
A fan whose materials are chosen so that accidental rubbing between the impeller and the casing does not produce a spark. It is one of the conditions of an ATEX execution, not the only one.
Who defines the ATEX zone?
The operator, in its explosion protection document. The fan supplier works from this zoning.
Is an ATEX motor enough?
No. If the air conveyed is explosive, the inside of the fan must also be designed for the zone: impeller, casing and clearances included.
Continue your selection
Related solutions and guides
Your industrial project
Tell us what you need.
Attach your zoning, the product safety data sheet or the dust characteristics, with the target airflow: we define the ATEX execution and send you a quote.
Contact us
Let’s talk about your installation.
A technician from our engineering office studies your needs and proposes the right solution for your workshop: machine, capture, ductwork and filtration.
Reply within 48 working hours.
Your request, step by step
-
1
You describe your needs
Pollutant, workstations, constraints: a few lines are enough. A photo of the installation helps us a lot.
-
2
Our engineering office studies it
Capture, airflow, ductwork and filtration are sized for your site, together with you if anything needs clarifying.
-
3
You receive a written proposal
Machine, options and price, in detail: you decide with full knowledge of the facts.
- Since 1994in industrial air treatment
- In-house engineering officefrom design to supply
- All brandsfilters and spare parts
- French Fabnetwork member
