
Bag-type DA
Low dust loads
250 – 2 000 m³/h
Data sheet Bag-type DAFrench industrial expertise · Since 1994
Bag, sleeve or cartridge; polyester, antistatic or PTFE: how to choose and replace the filter element of a dust collector.

01 / Bags, sleeves and cartridges
The bag, simple and economical, suits light loads: it is shaken or removed for cleaning. The sleeve, long and made of felt, withstands heavy loads and abrasive dust. The pleated cartridge offers a large area in a small volume and cleans well with compressed-air pulses.
Each unit is designed for one shape: a sleeve cannot be replaced by a cartridge without modifying the unit.
02 / Bags, sleeves and cartridges
Polyester: the standard medium for dry dust. Antistatic polyester: for combustible dust, it drains electrical charges to earth. PTFE membrane: the dust stays on the surface and releases better, useful for fine or greasy dust.
03 / Bags, sleeves and cartridges
Photograph the unit’s rating plate and the filter in place, note its dimensions (diameters and length for a cartridge or sleeve), the type of fixing and the medium if marked. We supply the compatible reference, including for units of other makes.
A filter is replaced when cleaning no longer brings the pressure drop back to its normal level, or in the event of a tear. A pressure-drop indicator shows it.
Compare the equipment
These data sheets let you compare technologies and operating conditions. Compatibility with your process and the equipment configuration are confirmed before the final choice.

Low dust loads
250 – 2 000 m³/h
Data sheet Bag-type DA
Occasional use
400 – 5 000 m³/h
Data sheet DA
Daily intermittent use
400 – 5 000 m³/h
Data sheet DAS
Continuous production 24/7
600 – 19 200 m³/h
Data sheet DAS CCUseful answers
Not without modifying the unit: fixing, support and cleaning are specific to each shape.
No. It removes one ignition source, but the unit must also be protected against explosion: vents, isolation and earthing of the whole assembly.
Continue your selection
Your industrial project
Send us photos of the workstations, the materials worked, which workstations run at the same time and your working hours: we size the capture and filtration and send you a costed quote.
Contact us
A technician from our engineering office studies your needs and proposes the right solution for your workshop: machine, capture, ductwork and filtration.
Reply within 48 working hours.
Your request, step by step
Pollutant, workstations, constraints: a few lines are enough. A photo of the installation helps us a lot.
Capture, airflow, ductwork and filtration are sized for your site, together with you if anything needs clarifying.
Machine, options and price, in detail: you decide with full knowledge of the facts.
Your cookie choices
With your consent, we use audience and advertising measurement cookies to understand how the site is used, improve it and see which ads bring us enquiries. You can accept, refuse or choose, and change your choice at any time. Learn more